Testing; Reconnect Battery; Test Power Wiring; Test Antenna Connection - Jensen CD615X Installation Instuctions

®

Testing

Before you finish the installation, you should do the following tests to make sure the wiring is correct
and everything is operating properly.

Reconnect Battery

When wiring is complete,
reconnect the battery
negative terminal.

Test Power Wiring

1. Turn ignition switch on. The display should
light and show 12:00. If not, check the
electrical connection at the yellow and red
wires.
BASS
2. Press PWR to turn the radio on. You will
see the radio display. If not, check electri-
cal connections to the red and yellow
wires.
3. If equipped, the power antenna should
also operate. If not, check electrical
connections to the dark blue wire.

Test Antenna Connection

1
VOL
VOL
1. Press >> or << . The radio should tune to a
nearby station. If not, check antenna
connection.
VOL
2
VOL
8
5293_Ein.p65
PROGRAM REPEAT RANDOM SCAN
VOL
or
VOL
2. Press to increase
VOL
volume until you can
hear the radio playing.
8

Test Memory Wiring

1. With the radio playing, hold
1
button 1 for five seconds. The
radio will beep. You just stored
the current station in memory.
5 Sec
2. Turn the key off, then turn the
2
key on again.
3. Press >> or << up or down.
3
VOL
The radio will select a different
station.
VOL
VOL
VOL
4. Press button 1 again. It should
4
return to the station that was
playing before (step 1). If not,
make sure the yellow wire is
connected properly.

Set the Clock

1. Press and hold DISP button
1
DISP
for 3 seconds until display
flashes.
3 Sec
2. Within 3 seconds, press >> to
2
0
1
change minutes, << to change
2
3
hours.
VOL
M
VOL
VOL
H
VOL
BASS PROGRAM REPEAT RANDOM SCAN
4/10/99, 11:19 PM
CD615X