Setting The Tv On The Wall; Removing The Stand - Sharp AQUOS LC-42G7H Operation Manual

Preparation

Setting the TV on the wall

• You can mount the TV on the wall, using the optional AN-37AG2/AN-52AG1 bracket.
• For details, refer to the instructions supplied with the optional bracket.
CAUTION
• This TV should be mounted on the wall only with the AN-37AG2/AN-52AG1 (SHARP) wall mount bracket. The use
of other wall mount brackets may result in an unstable installation and may cause serious injuries.
• Installing the Liquid Crystal Television requires special skill that should only be performed by qualifi ed service
personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper
mounting or mounting that results in accident or injury.
Using an optional bracket to mount the TV
• You can ask a qualifi ed service personnel about using an optional AN-37AG2/AN-52AG1 bracket to mount the TV to the wall.
• Carefully read the instructions that come with the bracket before beginning work.
Hanging on the wall
AN-37AG2/AN-52AG1 wall mount bracket.
(See the bracket instructions for details.)
Vertical mounting
NOTE
• Detach the cable clamps on the rear of the TV when using the optional mount bracket.

Removing the stand

For wall mounting with the optional bracket, remove the stand.
Before attaching/detaching the stand
• Before detaching (or attaching) the stand, unplug the AC cord from the AC outlet.
• Remove all terminal covers and connected cables.
• Lay the TV down on cushioning (such as a blanket) over a table.
• Make sure two or more people perform the operation.
CAUTION
• Do not remove the stand from the TV unless using an optional bracket to mount it.
1
Unfasten the screw used to secure
the cover in place.
NOTE
• To attach the stand, perform the above steps in reverse order.
Angular mounting
1
2
1 Unfasten the four screws used
to secure the stand in place.
2 Pull the stand several
centimetres toward you.
About setting the TV angle and height adjustment
1
0°
2
AN-37AG2 AN-52AG1
3
2
Detach the stand from the TV.
(Hold the stand so it will not drop
from the edge of the base area.)
For AN-52AG1
1 0°/5°/10°/15°/20°
2 -5/0/+5 cm
(can be moved 5 cm
up or down)
7