Land Pride ZT60i Operator's Manual page 54

Section 6: Specifications & Capacities
Mower Models
Overall width (Chute down)
Overall Width
Overall Length
With ROPS Down
Overall Height
With ROPS Down
Roll Over Protective Structure
Drive Tires
Front Tires
Hour Meter
Fuel Capacities
Steering Type
Twin Lever Steering Controls
Steering Turning Radius
Hydraulic Brake Service
Park Brakes
Ground Speed
Wheel Drive
Electrical Operated Logic-Control Safety
Features
Evaporative Emission Control System
on EPA Compliant Mowers
Seat Options
Mainframe Construction
Drive Motor Mount
Front Caster Wheels
Front Caster Forks
Deck Thickness
Box-Section Reinforced Front Edge
Deck Trim Edges
Deck Housing Depth
Deck Lift
Hand Operated Controls
Indicators
Cup Holder
Cutting Heights
Mowing Blades
Blade Tip Speed
Blade Drive
52 ZT60i & ZT72i (S/N 748110+) Accu-Z
Table of Contents
General Specifications & Capacities
At Rear Tires
AT Deck
With ROPS Up
With ROPS Up
Twin lever steering provides independent control of each drive wheel
True zero degree. Turns with counter-rotating independent drive wheels
Electric logic-control system governs blade engagement, forward & reverse motion,
This equipment uses a sealed fuel system which incorporates a non-vented fuel
cap. Evaporative emissions are vented to the engine where they are combusted
3/16" deck with 3/16" reinforcement plate connecting spindle housing mounts
blade engagement switch, choke knob and Fuel Tank Selector Valve
Electric clutch drive with single V-belt to three spindles and spring tension idler
®
Zero Turn Mowers 357-552M
ZT60i
74 1/4"
52"
74 1/4"
91 1/2"
49 3/4"
Certified ROPS, includes seat belt
24 x 12.00 - 12, Turf tread
13x6.5 - 6, Rib tire
Standard equipment
Twin 6 US GAL. tanks (Total fuel capacity = 12 US GAL.)
Speed, forward, reverse, brake, and turns
Hydrostatic dynamic braking
Internal wet disk, manual activated
Forward: 0-12 MPH
Reverse: 0-6 MPH
Single V-belt with spring tension idler pulley
engine starting & running, and parking brake functions.
during normal engine operation.
Deluxe cushion seat with arm rests
Optional Suspension seat with arm rest
Welded steel
Fabricated from 3/16" steel plate
Free turning with sealed for life roller bearings
3/8" steel
3/16" with solid 1" x 1/4" steel bar for reinforcement.
Solid 1" x 1/4" steel bar for reinforced trim edge.
5 3/16" deep, (room for high-capacity mowing)
Foot-operated deck height adjustment with transport position
Pin for setting height
Ignition switch, throttle lever, control levers, park brake lever,
Engine warning light and hour meter
Two cup holders molded into the left side fuel tank
They accommodate nearly any cup size
Height adjustment in 1/4" increments from 1" to 5"
Heavy-duty, heat-treated, high-lift Fusion
.25" x 2 1/2" x 21"
18,350 FPM
ZT72i
86 1/2"
52"
86 1/2"
88"
75"
®
edge
.25 x 2 1/2" x 25"
18,800 FPM
pulley
2/06/14