Sanyo VCC-6580 Instruction Manual page 7

MOUNTING THE LENS
3
1
2
4
2
3 1
ADJ. LOCK
4
LENS terminal
Lens iris output terminal which is used to connect the lens plug when the auto-iris lens is attached.
1 3
Brake coil (–) Drive coil (+)
2 4
Brake coil (+) Drive coil (–)
Flange-back adjustment
This normally does not need adjustment. If the picture is out of focus at the telephoto position, adjust the
flange-back position as described below.
1
Loosen the FLANGE BACK LOCK screw.
2
Set to the maximum telephoto position and focus the picture using the focus ring.
3
Set to the maximum wide-angle position and focus the picture using the FLANGE BACK ADJ.
screw.
Repeat steps 2 and 3 if the image does not stay in focus when changing from a wide-angle shot to
a telephoto shot.
4
When the setting is complete, tighten the FLANGE BACK LOCK screw.
6
English