White Balance Adjustment - Sanyo VCC-6580 Instruction Manual

SETTINGS

White balance adjustment

Normally the switch 9 (WB) is set to the down (ATW) position and
the white balance is adjusted automatically. If a manual white balance
adjustment is necessary, follow the steps below.
Set the switch 9 (WB) to the up (MWB) position, then adjust the
colour.
• Turn RED (VR302) to set the red ratio and/or BLUE (VR303) to set
the blue ratio.
VR302
9
RED
11
English
VR303
BLUE
Sync setting
LL: Line-Lock
Synchronizes the unit with power frequency when two or more
cameras are connected via a switcher unit.
When the image on the monitor rolls vertically, adjust the phase.
• If using this unit as the second or subsequent camera;
Adjust the roll by turning the LINE PHASE dial.
• If using this unit as the first camera;
Adjust the roll using the phase adjuster on the second and
subsequent cameras.
INT: Internal sync
10