Troubleshooting; Important Safety Instructions - Remington HC363C Instruction Manual

TROUBLESHOOTING

If blades do not seem to cut hair easily, the taper lever (PICTURE 6) can be used to remove
any hair caught between the comb and blade. Switch the clipper on and move the taper lever
up and down a few times but do not force the lever in either direction. This should remove
hairs and restore the cutting efficiency. If not, contact your nearest Remington
Centre.

IMPORTANT SAFETY INSTRUCTIONS

WARNING – TO REDUCE THE RISK OF BURNS, ELECTROCUTION, FIRE, OR
INJURY TO PERSONS:
080705_REM_IFU_HC363C_22L.indd 5 080705_REM_IFU_HC363C_22L.indd 5
ENGLISH
Brush out hairs from between the blades with soft cleaning brush. Do not remove the
lubricating grease from the blades. It is not necessary to remove the small moving blade
from the unit.
If the moving blade has been removed this can be re-fitted by slotting the ceramic blade
holder over the pin in the centre of the interior product head. The groove on the ceramic
blade, just below the teeth, rests on a metal plate at the opposite side to the screw holes.
The fixed blade is fitted with the raised profile pointing outwards and fixed with the 2
screws.
Before fully tightening the 2 screws, adjust the taper lever to the lower position and align
the blades so that their cutting edges are parallel to one another. Tighten the 2 screws.
Note that if the blades are not correctly aligned then cutting efficiency will be impaired.
Place a few drops of cutter or sewing machine oil onto the blades. Wipe off excess oil.
CAUTION: Do not use liquid cleaners on the blades or harsh or corrosive chemicals on
the blade casing. Always use a soft brush to remove the accumulated hairs.
Unplug the charge adaptor from the power outlet when fitting or removing attachments,
or while cleaning the product.
Always store this appliance and cord in a moisture-free area.
Do not wrap the cord of the charging adaptor around the appliance.
An appliance should never be left unattended when plugged into a power outlet.
Keep the power plug and cord away from heated surfaces.
Make sure the power plug and cord do not get wet.
Do not plug or unplug the shaver with wet hands.
Do not use the product with a damaged cord. A replacement can be obtained via our
International Service Centres.
Charge, use and store the product at a temperature between 15°C and 35°C.
Always unplug from the mains when cleaning.
Only use the parts supplied with the appliance.
®
Service
5
03.11.2008 19:06:40 Uhr 03.11.2008 19:06:40 Uhr