Removing The Doors - Electrolux ICON series Use & Care Manual

10

Removing the Doors

Getting through narrow spaces
If your refrigerator will not fit through an entrance
area, you can remove the doors. Check first by
measuring the entrance.
To prepare for removing the doors:
1 Make sure the electrical power cord is
unplugged from the wall outlet.
2 Open the freezer drawer and remove the toe
grille (see "Installation" section).
3 Remove any food from the door shelves and
close the doors.
To remove the top hinge covers:
1 Remove the two screws from each cover over
the top door hinges.
2 Lift inside edge of hinge cover and tilt back.
Top Hinge
Cover
Hinge
Screws
Multi-wire
Cables
Leave
Hinge
With
Door
NOTE
DO NOT remove the ground screw from hinge.
To remove the refrigerator doors:
1 Trace lightly around the door's top hinges with
a pencil. This makes reinstallation easier.
Front
Rear
Cover Screw
Cover
Screw
Ground
Screw
Top
Hinge
2 Disconnect the harness by grasping both sides
of the connector firmly, depress the latch, and
pull apart. Remove the two screws from the
top hinge. Lift the door off of the bottom hinge
and set it aside.
3 Unscrew the three lower hinge screws and
hinge if necessary.
To reinstall the right door, reverse the above steps.
Lower Hinge Removal
Once both doors are in place, ensure they are
aligned with each other and level (please see the
"Installation" section for more details), and replace
the top hinge cover.
CAUTION
Be sure doors are set aside in a secure position
where they cannot fall and cause personal injury,
or damage to the doors or handles.