Back Panel Connectors - Gigabyte GA-X99P-SLI User Manual

1-7

Back Panel Connectors

USB 2.0/1.1 Port
The USB port supports the USB 2.0/1.1 specification.
PS/2 Keyboard/Mouse Port
Use this port to connect a PS/2 mouse or keyboard.
USB 3.0/2.0 Port
The USB 3.0 port supports the USB 3.0 specification and is compatible to the USB 2.0/1.1 specification.
Use this port for USB devices.
DisplayPort In port
The DisplayPort In port offers vedio outputs to the motherboard. Refer to the Thunderbolt
for more information.
USB 3.1 Type-A Port (Red)
The USB 3.1 port supports the USB 3.1 specification and is compatible to the USB 3.0/ 2.0/1.1 specifica-
tion. Use this port for USB devices.
Thunderbolt 3 Connector (USB Type-C
™
The connector supports standard DisplayPort and Thunderbolt
DisplayPort/Thunderbolt
™
chain up to six Thunderbolt
number of Thunderbolt
™
being installed. You can adjust the Thunderbolt
Setup. The maximum supported resolution is 4096x2304@60 Hz when using a DisplayPort monitor, but the
actual resolutions supported are dependent on the monitor being used. Also, the connector is reversible
and supports the USB 3.1 specification and is compatible to the USB 3.0/2.0 specification. You can use
this port for USB devices, too.
Follow the steps below to install the DisplayPort or Thunderbolt
Step 1:
Connect the included DisplayPort cable (or Mini-
DisplayPort cable) from the graphics card to the
DisplayPort In port on the back panel.
Port)
™
monitor to this connector with an adapter. The Thunderbolt
devices. Because of the limited I/O resources of the PC architecture, the
™
devices that can be used is dependent on the number of the PCI Express devices
settings under Peripherals\Intel(R) Thunderbolt in BIOS
™
- 21 -
video outputs. You can connect a standard
™
™
devices:
™
Step 2:
Then connect the DisplayPort or Thunderbolt
deviecs to Thunderbolt 3 connector to complete.
™
Hardware Installation
3 Connector
™
connector can daisy
™