Table of Contents
Advertisement
A new system from the list is selected by using the RAMP control
or
,
or by directly entering the system number with the numeric keys. The
.
RAMP control
or
scrolls through the list in increasing and decreas-
,
.
ing order. In the previous example, pressing the RAMP control
selects
,
the EAST system as shown in the next display.
E A S T
S Y S =
3
The radio may be programmed to wrap around from one end of a list to the
other end or to stop at the ends.
DIRECT ACCESS
To directly access a selection, enter the corresponding number (i.e. 4) fol-
lowed by SEL to activate the selection. The entered number is displayed on
line two as shown below. Line one shows the current list being used for se-
lection.
S E L S Y S
4
If a mistake is made while entering the number, press the DEL
button to
backspace once and correct the entry. If an invalid number is entered, a short
?
low-pitched tone sounds when SEL is pressed.
To exit the selection mode, press the
button or wait for the time-out. If
the selection mode is cleared while an entry is pending (i.e., numbers are en-
tered on line 2, but SEL has not been pressed), the entry on line two will be
disregarded and the previous selection will remain active. If the time-out ac-
tivates while an entry is pending, the entry on line two will be selected if it is
within the valid range; if it is out of range, the entry on line two will be dis-
regarded and the previous selection will remain active.
NOTE: While in system, group or channel selection mode, the radio contin-
ues to receive calls normally and continues scanning if it is enabled. If a call
is received during the selection mode process the radio will return to the nor-
mal receive mode display. Continuing with the selection process will return
the display to the same point in the selection process if the selection mode
25
Advertisement
Table of Contents
