Starting And Operating Your Vehicle; New Vehicle Break-In - Chevrolet 2006 TrailBlazer EXT Owner's Manual

Table of Contents

Advertisement

If the engine stalls and the security light flashes, wait
about 10 minutes until the light stops flashing before
trying to restart the engine. Remember to release
the key from START as soon as the engine starts.
If the engine does not start after three tries, the vehicle
needs service.
If the engine is running and the security light comes on,
you will be able to restart the engine if you turn the
engine off. However, your Passlock
not working properly and must be serviced by your
dealer. Your vehicle is not protected by Passlock
this time. You may also want to check the fuse.
See Fuses and Circuit Breakers on page 5-109. See
your dealer for service.
In an emergency, call the GM Roadside Assistance
Center. See Roadside Assistance Program on page 7-6.
®
system is
®
at
Starting and Operating Your
Vehicle

New Vehicle Break-In

Notice: Your vehicle does not need an elaborate
break-in. But it will perform better in the long run if
you follow these guidelines:
Keep your speed at 55 mph (88 km/h) or less for
the first 500 miles (805 km).
Do not drive at any one constant speed, fast or
slow, for the first 500 miles (805 km). Do not
make full-throttle starts. Avoid downshifting to
brake, or slow, the vehicle.
Avoid making hard stops for the first 200 miles
(322 km) or so. During this time your new
brake linings are not yet broken in. Hard stops
with new linings can mean premature wear
and earlier replacement. Follow this breaking-in
guideline every time you get new brake linings.
Do not tow a trailer during break-in. See Towing
a Trailer on page 4-59 for the trailer towing
capabilities of your vehicle and more
information.
Following break-in, engine speed and load can be
gradually increased.
2-19

Advertisement

Table of Contents
loading

This manual is also suitable for:

2006 trailblazer

Table of Contents