Battery Not Charging; Check Washer Fluid; Curb View Activated; Change Engine Oil - Chevrolet 2006 TrailBlazer EXT Owner's Manual

BATTERY NOT CHARGING

If the battery is not charging during operation, this
message will appear on the DIC. Driving with this
problem could drain your battery. Have the electrical
system checked by your GM dealer as soon as possible.
See Voltmeter Gage on page 3-38. Press the select
button to acknowledge this message and clear it from
the DIC display.

CHANGE ENGINE OIL

This message is displayed when the engine oil needs to
be changed and service is required for your vehicle.
See Scheduled Maintenance on page 6-4 and Engine
Oil on page 5-18 for more information. Also see Engine
Oil Life System on page 5-23 for information on how
to reset the message. This message will clear itself after
10 seconds until the next ignition cycle.

CHECK TIRE PRESSURE

If your vehicle has a Tire Pressure Monitor (TPM)
system, and if a low tire pressure is detected in any
of the vehicle's tires, this message will appear on
the DIC, along with a chime. Press the select button to
acknowledge this message and clear it from the DIC
display. The message will appear at each ignition cycle
until the tires are inflated to the correct inflation
pressure.
3-56

CHECK WASHER FLUID

If the washer fluid level is low, this message will appear
on the DIC. Adding washer fluid to the windshield
washer fluid reservoir will clear the message. See
Windshield Washer Fluid on page 5-40. Press the select
button to acknowledge this message and clear it from
the DIC display.

CURB VIEW ACTIVATED

The CURB VIEW ACTIVATED message is displayed
when the passenger outside rearview mirror moves into
the curb view position. See Outside Curb View Assist
Mirror on page 2-48 for more information.

DRIVER DOOR AJAR

If the driver's door is not fully closed, this message
will appear on the display and you will hear a chime.
Stop and turn off the vehicle, check the door for
obstacles, and close the door again. Check to see if the
message still appears on the DIC. Press the select
button to acknowledge this message and clear it from
the DIC display.