Insert A Memory Card; Charge The Battery - Nokia 6600 Slide User Manual

Hide thumbs Also See for 6600 Slide:
Table of Contents

Advertisement

6
Make it your phone
3
Observe the battery contacts, and
insert the battery. Replace the back
cover.

Insert a memory card

Use only compatible microSD cards
approved by Nokia for use with this
device. Nokia uses approved industry
standards for memory cards, but some
brands may not be fully compatible with
this device. Incompatible cards may
damage the card and the device and
corrupt data stored on the card.
You phone supports microSD cards of up
to 4 GB.
1
Switch the device off, and remove the
back cover and battery.
2
Slide the memory card holder to
unlock.
3
Open the card holder, and insert the
memory card into the holder with the
contact surface facing inwards.
6
4
Close the card holder, and slide it to
lock.
5
Replace the battery and back cover.

Charge the battery

Your battery has been precharged, but the
charging levels may vary.
1
Connect the charger to a wall outlet.
2
Connect the charger to the device.
3
When the battery is fully charged,
disconnect the charger from the
device, then from the wall outlet.
You also may charge the battery with a
USB cable with power from a computer.
1
Connect the USB cable to the USB port
of a computer and to your device.
2
When the battery is full charged,
disconnect the USB cable.
If the battery is completely discharged, it
may take a few minutes before the
charging indicator appears on the display
or before any calls can be made.
The charging time depends on the charger
used. Charging a BL-4U battery with the
AC-8 charger takes approximately 1 hour
30 minutes while the phone is in the
standby mode.
© 2008 Nokia. All rights reserved.

Advertisement

Table of Contents
loading

Table of Contents