Table of Contents
Advertisement
Chapter 5. Tuning the Commands to Your Voice
ADAPTING
STORED
PHONEBOOK FULL
SPEECH TOO LONG
BAD TRAINING
REPHRASE
YES
10:00 SAT
JAN 10
-EXT100
100
Notes: • To exit the retraining procedure at any point before step 10, simply
DBS/824-770
Example: Say "Complete"
#2
it again."
10. Again say the control command to be retrained.
Voice Guidance responds with '"
sounds.
After storing your own voice in the system, execution returns to
step 6.
Example: Say "Complete"
'"Complete" stored.'
To continue retraining other commands, repeat steps 7 to 10.
• If the Phonebook memory is full
The following message is displayed on the screen and Voice
Guidance says "Phonebook Full sorry." If you want to continue
retraining the commands, you must first delete any unwanted
entries. (See Chapter 4, "Deleting a Phonebook Entry" (page
23).)
• If the spoken command is too long
The following message is displayed and Voice Guidance
responds with "Try again." Repeat the procedure from step 8
making the command shorter. (The maximum recording time
per entry is 2.5 seconds.)
• If the tone used in step 10 differs from that used in step 9
The following message is displayed and Voice Guidance
responds with "Try again". Repeat the procedure from step 8.
• If the recorded name is identical to an existing entry
The following message is displayed and Voice Guidance
responds with "'
to step 8. Create the entry using a different name.
11. Replace the handset.
replace the handset.
• You can press the Cancel Key at any point to display the TOP
MENU, allowing you to store new entries or edit or delete existing
entries. This function can be useful if you want to check the
contents of the Phonebook or place a call during the retraining
procedure.
(USA) issued April 2000
Section 770 Voice Recognition Telephone
Voice Guidance responds with "Say
" stored' and the Splash tone
mm
Voice Guidance responds with
' Conflict. Try again." Enter "Yes" to return
mm
31
Advertisement
Table of Contents
