MAINTENANCE
PROCEDURE
Tighten all Screws and
Nuts
Check Traction Clutch
Cable Adjustment (See
Cable Adjustment)
Check Auger Clutch
Cable Adjustment (See
Cable Adjustment)
SNOW THROWER
Adjust Drive Belts
Lubricate Chains and Hex
Shaft
Lubricate Auger Shaft
(See Shear Pin Replace-
ment)
Lubricate Free-Hand
Linkage
Oil, Check
ENGINE
Oil, Change
NOTE: The warranty on this snow thrower does not cover items
that have been subjected to operator abuse or negligence. To
receive full value from the warranty, operator must maintain
snow thrower as instructed in this manual.
The above Service Recom mendations are supplied to assist the opera-
tor to properly maintain the snow thrower. This is a check list only. Adjust-
ment referred to will be found in the MAINTENANCE section of this
manual.
SERVICE RECOMMENDATIONS
FIRST
BEFORE
2
EACH
OFTEN
HOURS
USE
✓
✓
✓
✓
✓
✓
✓
✓
AFTER EACH USE
1. Check for any loose or damaged parts.
2. Tighten any loose fasteners.
3. Check and maintain the auger.
4. After each use, remove all snow and slush off the snow thrower to
5. Check controls to make sure they are functioning properly.
6. If any parts are worn or damaged, replace immediately.
18
EVERY
EVERY
EVERY
5
10
HOURS
HOURS
HOURS
✓
✓
✓
✓
prevent freezing of auger or controls.
BEGINNING
BEFORE
25
EACH
STORAGE
SEASON
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓
✓