Timing Belt Inspection; Lubrication Points - Mercury 25 Jet 4-Stroke Manual

Timing Belt Inspection

1. Inspect the timing belt and have it replaced by an authorized
dealer if any of the following conditions are found.
a. Cracks in the back of the belt or in the base of the belt teeth.
b. Excessive wear at the roots of the cogs.
c. Rubber portion swollen by oil.
d. Belt surfaces roughened.
e. Signs of wear on edges or outer surfaces of belt.

Lubrication Points

1. Lubricate the following with Quicksilver or Mercury Precision
Lubricants Anti‑Corrosion Grease or 2‑4‑C with Teflon.
Tube Ref No.
Anti-Corrosion
94
Grease
2-4-C with Teflon
95
• Driveshaft bearing
IMPORTANT: It is important not to use a general all purpose
grease for this bearing. The lubricant recommended is a water
resistant grease of the proper consistency for this application. If a
substitute is used, be sure that it is water resistant and of the same
consistency.
i. Pull the vent hose off of the grease fitting.
MAINTENANCE
Description Where Used
Driveshaft bearing
Driveshaft bearing
84
9697
Part No.
92-802867A1
92-802859A1