Table of Contents
Advertisement
Using the network mailbox
The network mailbox is your network pro-
vider's answering machine. You cannot
use the network mailbox unless you have
requested it from your network provider.
Using the network mailbox to
set fast access
With fast access, you can dial either your
network mailbox or the integrated
answering machine directly.
The integrated answering machine is pre-
configured for fast access. You can config-
ure the network mailbox by obtaining
information from your network provider.
Configuring your network mailbox for fast
access, and entering the network mailbox
number
¢
¢
Voice Mail
§Menu§
¢
¢
Network Mailbox
§OK§
¢
Enter the number of the network
¢
mailbox
§OK§
This setting is now valid for all registered
handsets.
Calling your network mailbox
1
Press and hold. This connects
you directly to your network
mailbox.
Viewing your network mailbox
messages
When a message arrives, you will receive a
call from the network mailbox. If you have
signed up for Caller ID, the display shows
the network mailbox number. If you
accept the call, the new messages are
played back. If you do not accept the call,
the network mailbox number will be
stored in the list of missed calls (page 25).
¢
Set Key 1
§OK§
¢
(‰ = on)
§OK§
Using the network mailbox
Using several handsets
Registering handsets
You can register up to four handsets to
your base station.
Automatically registering the handset to
the Gigaset E365 base station, see
page 12.
Manually registering the handset to
the Gigaset E365
You must activate manual registration of
the handset to both the handset and the
base station.
After registration, the handset returns to
idle status. If several handsets are regis-
tered to the base, the internal number of
each is shown on the screen after registra-
tion (for example, 2).
The registration process is canceled after
60 seconds. If the handset has not regis-
tered within that time, repeat the process.
On the handset
¢
¢
Settings
§Menu§
¢
¢
Register Handset
§OK§
¢
Enter system PIN of base station
(default status: 0000)
On the base station
ù
Press and hold the Registra-
tion/Paging key on the base
station (page 2) (min. 1 sec.).
Locating a handset ("paging")
You can locate your handset using the
base station.
¤
Press the Registration/Paging key ù of
the base station (page 2) briefly.
¤
All handsets will ring at the same time
("paging"), even if the ringers are
switched off.
¢
Handset
§OK§
¢
§OK§
¢
§OK§
29
Advertisement
Table of Contents
