Position Of The Looper Crosswise To The Sewing Direction - Pfaff 5625-657/01 Instruction Manual

Adjustment
11

Position of the looper crosswise to the sewing direction

.04.09
11 - 10
Requirement
When its point is positioned in the centre of the needle, looper 1
1. Should be parallel to the needle plate cut-out and
2. There should be a distance of 0.1 mm between the looper point and the needle.
1
2
3
4
Fig. 11 - 09
Position the looper point to the centre of the needle by turning the balance wheel.
Align looper 1 (screws 2 ) in accordance with requirement 1.
Adjust holder 3 (screw 4) in accordance with requirement 2.
62-031
1
0,1 mm
62-069