Care And Maintenance; Maintenance Intervals; Cleaning The Machine - Pfaff 5704 Instruction Manual

Care and maintenance

10 Care and maintenance
10

Maintenance intervals

.01
10

Cleaning the machine

.02
The cleaning cycle required for the machine depends on following factors:
It is therefore only possible to stipulate the best possible cleaning instructions for each indivi-
dual case.
To avoid breakdowns, the following cleaning work is recommended for single shift operation:
10 - 1
Clean the machine ........................ once a day, more often when in continuous operation
Clean the hook compartment ........ once a day, more often when in continuous operation
Check the oil level ..................................................................................................... daily
Change the oil ............................... 4 weeks after commissioning, then every six months
Oil the thread lubrication .................................................................................. as required
Oil the machine ..................................... during commissioning and after long downtimes
Change the knife .............................................................................................. as required
These maintenance intervals are calculated for the average running time of a
single shift operation. If the machine is operated more than this, shorter
intervals are recommended.
Single or several shift operation
Amount of dust resulting from the workpiece
For all cleaning work the machine must be disconnected from the mains by
switching off the on/off switch or by disconnecting the mains plug!
Danger of injury if the machine starts accidentally!
Clean hook compartment and needle area several times a day.
Clean the entire machine at least once a day.