Update Firmware; Factory Defaults - Muratec Office Bridge IF-200 Operating Instructions Manual

RX packets
TX errors
RX errors
CRC errors
RUNT errs
DATA errs
OOW errors
JABBER err
Collisions
Underruns
RX misses

7.5. Update Firmware

If the IF-200 has received a firmware update, the user must go to the Advanced
Settings menu, Update Firmware option and accept (Yes) or discard (No) the received
update.
Alternatively, the user may configure the IF-200 to automatically accept and apply
firmware updates. To enable this feature, go to SETUP->Advanced Settings->Expert
Setting->Auto Apply Firmware and select YES.
Firmware updates are received as special email messages.
NOTE:

7.6. Factory Defaults

Factory Defaults deletes all of the settings you entered and resets the IF-200 back to
the factory installed defaults. All ISP and mailbox information is lost.
To set the IF-200 back to the factory installed defaults, press SETUP from the Main
screen. Scroll to Advanced Settings and press EDIT. Scroll to Factory Defaults and
press EDIT.
Once deleted, there is no way to recover the settings.
number of reception
attempts
number of transmission
errors
number of reception errors
source of reception errors
source of reception errors
source of reception errors
source of reception errors
source of reception errors
source of reception errors
source of transmission
errors
source of reception errors
WARNING
Appendix B
31