System Phase Alignment; Setup Menu Settings - Sony MSW-A2000 Installation Manual

1-15. Settings and Adjustment when External Equipment is Connected

1-15-3. System Phase Alignment

An external reference video signal and analog composite signal must be input to MSW-A2000/A2000P
after they are adjusted so that SC-H conforms to the specifications.
When Connecting to a Digital Switcher
Fundamentally, the system phase adjustment is not necessary.
Refer to the manual of the digital switcher for details.
When Connecting to an Analog Switcher
Perform the system phase adjustment according to the manual of the analog switcher.
To adjust the system phase of this unit, open the P3 page (VIDEO OUT CONTROL2 & MISC) and use
the MULTI CONTROL knob.
When adjusting (i.e. changing the settings), press the button below to blink the current setting value, and
then turn the MULTI CONTROL knob.
Button Item (Display)
F1 SYSTEM SYNC PHASE (SYNC)
F2 SYSTEM SUBCARRIER PHASE (SC)
m
. Be sure to adjust in PB mode.
The system phase does not change even if the SYNC/SC is adjusted in the REC mode, but it changes
when the REC mode is shifted to the PB mode.
. The playback sound may be momentarily interrupted when the SYNC/SC is adjusted during tape
playback.

1-15-4. Setup Menu Settings

Video/Sync Delay Setting "ITEM-701"
Commonly, when integrating the menu into the editing system, set to "VIDEO".
To prevent the picture shift during EE/PB switching in the VTR-to-VTR edit operation, this setup menu is
also set to "VIDEO".
Analog Component Signal Format Setting "ITEM-709" (525/60 system only)
The input (SUB-ITEM-0) and output (SUB-ITEM-1) sides are set to "D-1" or "B-CAM" according to the
operating system, respectively.
1-24
MSW-A2000
MSW-A2000P