Lighting - Stanley Lismore Installation And Operating Instructions Manual

Non boiler wood burning stove

Hide thumbs Also See for Lismore:

Table of Contents

Before lighting the stove check with the installer that the installation work and

commissioning checks described in the installation instructions have been carried

out correctly and that the chimney has been swept clean, is sound and free from any

obstructions. As part of the stove's commissioning and handover the installer

should have demonstrated how to operate correctly.

Fig.20

Open firedoor and open the primary air inlet by lowering the lever on the rear of the stove

to setting.

Open both the primary and secondary air controls.

Cover with crumpled pieces of paper.

Lay 10-12 pieces of kindling on top of the paper towards the back of the firebox.

Ignite and close the firedoor.

Under no circumstances should any flammable liquid i.e. petrol, paraffin etc., be

used to light the fire.

When the kindling is well alight open the firedoor and add more kindling of a larger size

to sustain the fire. Close the firedoor.

When a hot fuel bed is established add the normal fuel.

When well lighted, adjust the thermostat to give the required heat output.

10.

To shut the fire down, do not add fuel, make sure that the firedoor is properly closed and

that the primary and secondary air controls are all in the closed position. Cutting off the

air supply will reduce the heat output.

11.

Following a prolonged shutdown of the appliance perhaps after the summer break,

ensure the flueway is free from obstruction prior to re-lighting.

Re-fuelling-Open the firedoor and reload, close the firedoor.

LIGHTING

Table of Contents