Table of Contents
Advertisement
■
Programming HomeLink
For U.S.A. owners
Programming an entry gate (for U.S.A. owners)/Programming a device in the
Canadian market
2
With one hand, press and hold the HomeLink
other hand, press and release the remote control transmitter every 2 seconds and
repeat this cycle until the HomeLink
release the buttons.
3
Test the HomeLink
ing the indicator light:
● If the indicator light is solid/continuous, programming has been completed and your
device should activate when the HomeLink
● If the indicator light blinks rapidly for 2 seconds and then turns into a solid/continu-
ous light, proceed to the heading "Programming a Rolling Code System".
4
Repeat the steps above to program another device for any of the remaining
®
HomeLink
CT200h_QG_OM76210U_(U)
®
®
operation by pressing the newly programmed button and observ-
buttons.
1
Point the remote control transmitter for
the device 1 to 3 in. (25 to 75 mm)
from the HomeLink
Keep the HomeLink
view while programming.
2
Press and hold the HomeLink
you want to program and the remote
control transmitter button simulta-
neously. When the HomeLink
tor light changes from slowly flashing
orange to rapidly flashing green (roll-
ing code) or continuously lit green
(fixed code), release both buttons.
®
button you want to program. With your
®
indicator light starts to flash rapidly. Then,
®
button is pressed and released.
®
buttons.
®
indicator light in
®
button
®
indica-
78
Advertisement
Chapters
Table of Contents
