Assembly; Support Handle; Edger Blade Installation - Echo BRD-280 Operator's Manual

ASSEMBLY

ASSEMBLY

Support Handle

1. If necessary, position support handle for comfortable
operation and securely tighten screws.
Note: Label shows minimum spacing for support handle
location.

Edger Blade Installation

1. Remove bed redefining blade as shown in "Blade
Replacement" Section. Discard used split pin.
2. Do not remove inner blade adapter (A) or locking tool (B).
3. Install and center edger blade (C) on inner adapter.
4. Install outer adapter (D) and nut (E).
5. Tighten nut (E) firmly, counterclockwise.
6. Remove locking tool (B).
7. Install new split pin (F) to secure nut (E).
14
BRD-280
A
B
F
C
E
D
X7502314001
© 04/2015 ECHO Inc.