Goodman GMVC950704CX Installation Instructions Manual page 44

COMFORTNET™ SYSTEM
Installer
Clean Display
Config
Upon entering the advanced menus, the Advanced Fault Menu is
displayed. The display will change to the Fault Screen and indi-
cate any faults that may be present in the indoor or outdoor
equipment. If a fault is present, the Fault Screen will show the
equipment and an error code with a description of the fault. Touch
_
or keys to view the fault status of any remaining equip-
+
ment. The text "NO FAULTS" will be scrolled if no errors are
present.
Call for Service
Advanced
Menu
Run
Schedule
Touch the or to step through the list of installed equip-
ment, including the thermostat. Touch the Installer Config key
to enter the submenus for the equipment displayed. The text
"WORKING" will be displayed in the scrolling display area while
the data is being retrieved. The first sub-menu is then displayed.
See tables below for listing of furnace submenus.
Set Time
R un
Set
Sch ed u le
Schedule
Call for Service
Advanced
Menu
Run
Schedule
Touch the or to step through the list of submenus and view
settings. If a setting can be adjusted,
_
pear. Use the or +
value. Touch the or
ING" will appear as the settings are being updated. "DONE" will
appear to indicate the change was accepted. If the change is not
accepted, the display will show "FAIL" then revert to the Fault
Screen.
Some parameters being displayed switch between the item name
and the item value. Touch the Hold key to momentarily stop the
display from switching.
To exit an equipment submenu and revert back to the equipment
menus, touch the Menu key. Touch Menu again to revert back
to the Thermostat Options Menu. Touch the Run Schedule key
to step out of all menus and back to the CT thermostat Home
Screen Display.
44
_
and +
keys to adjust the setting to the desired
to step to the next item. "WORK-
keys will ap-