Table of Contents
Advertisement
MT4X56USB Drivers for Windows NT 4.0
Because NT 4.0 does not support USB, Multi-Tech provides a USB stack that will be installed along
with the necessary drivers. To do this, you must have have NT Service Pack 3.00 or higher and an
account that has administrative privileges.
Note: "Plug-and-Play" operations are not supported in an NT 4.0 (or earlier) operating system.
1. Ensure that power to the MT4X56USB is on but that the USB cable remains disconnected.
2. Insert the MT4X56USB Disk 2 into drive A.
3. Click Start | Run.
4. Type A:\setup and click OK.
5. The install program prompts you to make certain you have NT Service Pack 3.00 or higher. Click
Yes to continue.
6. The MultiModemUSB Drivers Install dialog box displays.
Click Next >.
7. The Read Multi-Tech Software License agreement screen is displayed. Read carefully. If you
accept the terms of the agreement, click Yes.
8. The Release Notes screen is displayed (Release Notes can also be found after installation in the
Start menu under Programs | Multi-Tech USB Utilities).
Click Next >.
MT4X56USB
Chapter 3 - Software Loading and Configuration
21
Advertisement
Table of Contents
Troubleshooting
