S-Registers - Multitech MultiModem MT4X56USB User Manual

S-Registers

Certain modem values, or parameters, are stored in memory locations called S-registers. Use the S
command to read or to alter the contents of S-registers (see previous section).
Register Unit
S0 1 ring
S1 1 ring
S2 decimal
S3 decimal
S4 decimal
S5 decimal
S6 seconds
S7 seconds
S8 seconds
S9 decimal
S10 100 ms
S11 1 ms 5
S28 decimal
S30 1 minute
S35 decimal
S36 decimal
S37 decimal
* These values may be different outside North America.
MT4X56USB
Chapter 4 - AT Commands, S-Registers and Result Codes
Range Default Description
0, 1–255 1 Sets the number of rings until the modem answers. ATS0=0
disables autoanswer completely.
0–255 0 Counts the rings that have occurred.
0–127 43 (+) Sets ASCII code for the escape sequence character.
128–255 Values greater than 127 disable escape.
0–127 13 (^M) Sets the ASCII code for the carriage return character.
0–127 10 (^J) Sets the ASCII code for the line feed character.
0–32 8 (^H) Sets the ASCII code for the backspace character.
33–127 Values greater than 32 disable backspace.
2–65* 2* Sets the time the modem waits after it goes off-hook before it
begins to dial the telephone number.
1–255* 50* Sets the time the modem waits for a carrier signal before
aborting a call. Also sets the wait for silence time for the @
dial modifier.
0–65 2 Sets the length of a pause caused by a comma character in
a dialing command.
0, 1–127 37 (%) Sets ASCII code for remote configuration escape character.
S9=0 disables remote configuration.
1–254 20 Sets how long a carrier signal must be lost before the
modem disconnects.
0–150* 95* Sets spacing and duration of dialing tones.
0, 1–255 1 0 disables, 1–255 enables V.34 modulation.
0, 1–255 0 Sets the length of time that the modem waits before
disconnecting when no data is sent or received. A value of
zero disables the timer. See also the \T command
0–1 0 0 disables, 1 enables the V.25 data calling tone, which allows
remote data/fax/voice discrimination.
0–7 7 Specifies the action to take in the event of a negotiation
failure when error control is selected. (See S48.)
0–19 0 Sets the maximum V.34 "upstream" speed at which the
modem attempts to connect.
0 = maximum modem speed
1 = reserved
2 = 1200/75 bps
3 = 300 bps
4 = reserved
5 = 1200 bps
6 = 2400 bps
7 = 4800 bps
8 = 7200 bps
9 = 9600 bps
10 = 12000 bps
11 = 14400 bps
12 = 16800 bps
13 = 19200 bps
14 = 21600 bps
15 = 24000 bps
16 = 26400 bps
17 = 28800 bps
18 = 31200 bps
19 = 33600 bps
49