Multitech MultiModem II MT5600BA–V.90 User Manual page 26

CALLBACK SECURITY. Use the à and Enter buttons to turn callback security on
or off. Same as the #DB0 and #DB1 commands. For more information about call-
back security, see Chapter 6, "Callback Security."
S-REGISTER OPTIONS. Use the à, â, and Enter buttons to display the current
S-register values and enter new values. Same as the Sr? and Sr=n commands.
MONITOR OPTIONS. Use the à, â, and Enter buttons to display line quality and
the line signal-to-noise ratio.
Multi-Tech Systems, Inc. MT5600BA/BL Series User Guide
PASSWORD SETUP. Use to enter callback security passwords
in memory locations 1–30. Each password must be six to ten
characters in length. To scroll through a list of digits and charac-
ters, press the á ß and â buttons. To go to the next position,
press the à button. To back up or to exit without saving, press
the à button several times. To save the password, press the
Enter button. Same as the #CBP= command.
CALLBACK NUMBER. Use to enter callback security phone
numbers in memory locations 1–30. Each number can be up to
30 characters long. Same as the #CBN= command. Note: Only
16 characters can be displayed at a time. To see characters 17–30,
press the â button. To go to the previous screen, press the ß
button. To go to the next screen, press the à button.
VIEW S-REGISTER SETTINGS. Use the à, â, á ß , and Enter
buttons to select the number of the S-register whose value you
want displayed. To scroll through a list of digits, press the á ß
and â buttons. To go to the next position, press the à button.
To back up or to exit without saving, press the à button several
times. To display the value, press the Enter button. Same as
the Sr? command.
SET S-REGISTER. Use the à, â, á ß , and Enter buttons to
select the number of the S-register whose value you want to
change, and the value you want to enter. To scroll through a list
of digits, press the á ß and â buttons. To go to the next posi-
tion, press the à button. To back up or to exit without saving,
press the à button several times. Same as the Sr=n com-
mand.
LINE QUALITY. Use the à and Enter buttons to display line
signal quality as a three-digit number. The higher order byte of
the EQM value is displayed. Based on the EQM value, retrain or
fallback/fall forward may be initiated if enabled by %E1 or %E2 .
Same as the %Q command.
SIGNAL TO NOISE RATIO. Use the à and Enter buttons to
display the line signal-to-noise ratio in dB.
Chapter 3 - Using the Front Panel
26