Table of Contents
Advertisement
Command
#Vn
W
&Wn
Xn
#Xn
Yn
Z
,
:
CommPlete Communications Server
Values
Description
n = 0 or 1
V.32terbo Handshake
*** #V0
Enable V.32terbo tones in answer mode.
#V1
Disable V.32terbo tones in answer mode.
In dialing
Wait for New Dial Tone
command
Causes modem to wait for new dial tone. (X2 or X4
must be selected.)
n = 0 or 1
Store Configuration
&W0 Store current settings in NVRAM; modem will
load these at power-on or with the ATZ
command instead of reading factory ROM
defaults.
*** &W1 Do not store settings.
n = 0–4
Result Codes and Call Progress Selection
*** X0
Basic result codes (CONNECT only); does not
look for dial tone or busy.
X1
Extended result codes (w/ CONNECT 1200,
CONNECT 2400, etc.); does not look for dial
tone or busy signal.
X2
Extended result codes with NO DIAL TONE;
does not look for busy signal.
X3
Extended result codes with BUSY; does not look
for dial tone.
X4
Extended result codes with NO DIAL TONE
and BUSY.
n = 0 or 1
Number of XOFF Characters Sent
*** #X0
Single XOFF character sent after buffer is full.
#X1
Multiple XOFF characters sent (one for every
character received after buffer is full).
n = 0 or 1
Long Space Disconnect
*** Y0
Disable sending or responding to long space
break signal on disconnect.
Y1
Enable sending or responding to long space
break signal on disconnect. (Both modems
must have Y1 set.)
n/a
Modem Reset
Reset modem to default values. Defaults come from
NVRAM if &W0 is set, from ROM if &W1 is set.
In dial
Dialing Pause
command
Comma; causes dialing pause for time set by S8.
At end of dial
Continuous Redial
command
Colon; causes continuous redial of number until
answered (10 in North American models). Not used in
U.K. or International models.
E AT Command Summary
83
Advertisement
Table of Contents
