Table of Contents
Advertisement
Appendices
Call Attempts/Retries:
Applications software shall be configured so that no more than 3 attempts
are made to establish a connection to a given number (Note: if the modem
can detect service tones, up to 10 attempts can be made). There must be
at least 2 seconds between call attempts.
If the call sequence is
unsuccessful, there shall be a delay of at least 30 minutes before
attempting to call the number again.
Failure to set the modem, and any communications software used
with the modem, to the values shown above will result in the modem
being operated in a non-compliant manner. Consequently, there
would be no permit in force for this equipment, and the
Telecommunications Act 1991 prescribes a penalty of $12,000 for
the connection of non-permitted equipment.
For Voice Modems:
"Distortion may be generated because of low bit rate voice, and reduced
voice quality may result."
"WARNING: For safety reasons, only connect AUSTEL permitted or
AUSTEL certified equipment."
Refer to the applicable MultiModemII Owner's Manual for additional
information.
Protection Against Contact with TNV Circuit (Internal PC Cards)
The protective cover is fastened to the modem card by means that will
only allow a tool to remove the cover. "Warning: removal of the protective
cover will render the AUSTEL permit void."
New Zealand Telecom Warning Notice
"Use of pulse dialing, when this equipment is connected to the same line
as other equipment, may give rise to "bell tinkle" or noise and may also
cause a false answer condition. Should such problems occur, the user
should NOT contact the Telecom Faults Service."
"The preferred method of dialing is to use DTMF tones, as this is faster
than pulse (decadic) dialing and is readily available on almost all New
Zealand telephone exchanges."
"WARNING NOTICE:
No '111' or other calls can be made from this
device during a mains power failure".
65
Advertisement
Table of Contents
