Table of Contents
Advertisement
Federal Communications Commission Statement
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy, and if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in which case the user will be
required to correct the interference at his own expense.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Important Safety Instructions
Caution: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent
type recommended by the manufacturer. Dispose of used batteries according to the manufacturer's
instructions.
The MR9600 Controller circuit board includes a battery that maintains the MR9600's setup information
when it is turned off or disconnected from power. The battery can maintain the setup information for
approximately 10 years with no external power, and longer when the MR9600 is turned on and operating
normally. This battery is soldered onto the circuit board and cannot be replaced by the user.
If, for some reason, the MR9600's battery should fail, please contact Multi-Tech Technical Support at (800)
972-2439 for replacement instructions.
CommPlete Communications Server
iii
Advertisement
Table of Contents
