Black & Decker BDCDMT112 Instruction Manual page 8

4.Thebattery p ack should b erecharged when itfailstoproduce s ufficient power onjobswhich
were easily done previously. DONOT CONTINUE touseunder these conditions. Follow the
charging procedure. Youmay alsocharge a partially used pack whenever youdesire withno
adverse a ffect onthebattery p ack.
5.Foreign materials ofa conductive nature s uch as,butnotlimited t o,steel w ool, a luminum
foil,oranybuildup o fmetallic particles should bekept a way from charger cavities. Always
unplug t hecharger from thepower s upply w hen there isnobattery
pack inthecavity. Unplug c harger before a ttempting toclean.
6.Donotfreeze o rimmerse charger inwater o ranyother l iquid.
Z_WARNING:
Shock hazard. Do not allow any liquid to get inside
charger.Never attempt to open the battery pack for any reason, ff the
plastic housing of the battery pack breaks or cracks, return to a
service center for recycling.
12VOLT MAX* INSTALLING AND REMOVING THE BATTERY
PACK FROM THE POWER UNIT
Always ensure the forward/reverse slider (7) is in the center position
when installing and removing batteries.
z_WARNING:
Make certain the lock-off button is engaged to
prevent switch actuation before removing or installing battery.
TO INSTALL BATTERY PACK: Insert battery pack into the Power
Unit, until an audible click is heard as shown in Figure B. Make sure
the battery pack is fully seated and latched into position.
TO REMOVE BATTERY PACK: Depress the battery release button
(3) as shown in Figure C and pull battery pack out of the Power Unit.
20VOLT MAX** BATTERY PACK (BDCDMT120) CHARGING, INSTALLING,
AND REMOVING
20VOLT MAX** CHARGING PROCEDURE
Black & Decker chargers are designed to charge Black & Decker
batterypacks in 3.5-4 hours depending on the pack being
charged.
1. Plug the charger (4) into an appropriate outlet before inserting
the battery pack (5). .
2. Insert the battery pack into the charger as shown in F!gure D.
3. The green LED will flash indicating that the battery is being
charged.
4. THe completion of charge is indicated by the green LED remaining
on continuously. The pace is fully chargedand may be used at this
time or left on the charger.
Recharge discharqed batteries as soon as possible after use or battery life may_
be greatly diminished. For Ionqest battery life, do not discharge batteries fully. It is
recommended that the batteries be recharged after each use.
LEAVING THE BATTERY IN THE CHARGER
The charger and battery pack can be left connected with the green LED glowing indefinitely.
The charger will keep the battery pack fresh and fully charged.
IMPORTANT CHARGING NOTES
1. Longest life and best performance can be obtained if the battery pack is charged when the
air temperature is betweeno65 F and 75 F (18 - 24 C)o.DO NOT charge the battery pack in an
air temperature below +40 F (+4.5 C), or above +105 F (+40.5 C). This is important and will
preventserious damage to the battery pack.
2. The charger and battery pack may become warm to touch while charging. This is a normal
condition and does not indicate a problem. To facilitate the cooling of the battery pack after
use avoid placing the charger or battery pack in a warm environment such as in a metal shed
or an un nsu atedtra er.