Safety Equipment - Black & Decker BDCDMT112 Instruction Manual

• Keep your hair, clothing, and gloves away from air vents. Air vents often cover moving
parts in which these items can be caught.
• Hold tool firmly with two hands, one hand on the handle, and the othergripping the bottom
around the battery area. Use auxiliary handle if provided. Loss of control can cause personal injury.
zLWARNING:
Some dust created by power sanding, sawing, grinding, drilling, and other
construction activities contains chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
. lead from lead-based paints,
• crystalline silica from bricks and cement and other masonry products, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and
other construction activities. Wear protective clothing and wash exposed areas with
soap and water. Allowing dust to get into your mouth, eyes, or lay on the skin may promote
absorption of harmful chemicals.
z_WARNING:
Use of this tool can generate and/or disperse dust, which may cause serious
and permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory
protection appropriate for the dust exposure. Direct particles away from face and body.
• Wear appropriate hearing protection during use. Under some conditions and duration of use,
noise from this product may contribute to hearing loss.
z_WARNING:
ALWAYS use safety glasses. Everyday eye glasses are NOT safety
glasses. Also use face or dust mask if cutting operation is dusty.
ALWAYS WEAR CERTIRED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CPA Z94.3),
• ANSI $12.6 ($3.19) hearing protection,
• NOSH/OSHA respiratory protection.
SYMBOLS
The label on your tool may include the following symbols. The symbols and their definitions are as follows:
V .................. volts
Hz................ hertz
min .............. minutes
- - -. ............ direct current
@ ................ Class I Construction
(grounded)
[] ................ Class II Construction
(double insulated)
............ Readinstructionmanual b eforeuse
G ................ Use proper eye protection
A ................... amperes
W.................. watts
,_ ................ alternating current
no ................. no load ,speed
8. ................. earthing terminal
z_ ................ safety alert symbol
.../min or rpm...revolutions or
reciprocation per minute
.................. Use proper respiratory protection
0 .................. Use proper hearing protection
These products use the batteries
Description
12v Max* Battery:
12v Max* Battery Charger:
20v Max** Lithium-Ion Battery:
20v Max** Lithiurmlon Battery:
20v Max** Lithium-Ion Battery Charger:
2 Amp Fast Charger:
2 Amp Fast Charger:
4
and chargers listed in the chart below.
Catalog #
LB12 / LBX12
LCS12
LBXR20
LB20 / LBX20
LCS20
L2AFC
L2AFCBST