Honda TRX420TM1 Owner's Manual page 147

14 TRX420TM1 FM1 FM2-32HR36000.book 139 ページ ２０１３年８月２７日 火曜日 午後７時３７分
3. Remove the oil filter cover (1) and O-rings (2) by removing the
bolts (3). Let the remaining oil drain out. Discard the oil filter (4)
in an approved manner (page 212).
4. Apply engine oil to a new O-rings and install them to the oil filter
cover and crankcase cover. Then install a new oil filter. Use only
the Honda Genuine oil filter or a filter of equivalent quality
specified for your model. Using the wrong Honda filter or a non-
Honda filter which is not of equivalent quality may cause engine
damage.
5. Reposition the spring (5) to the engine crankcase and install a
new oil filter with the rubber seal (6) facing out, away from the
engine. You will see the "OUTSIDE (TOWARDS FILTER COVER)"
mark (7) on the filter body, near the seal.
NOTICE
Improper installation of the oil filter can cause serious engine
damage.
RIGHT SIDE
(1)
(3)
(1) oil filter cover
(2) O-rings
(3) bolts
(4) oil filter
Engine Oil & Filter
(2)
(6)
(5)
(4)
(7)
(2)
(5) spring
(6) rubber seal
(7) "OUTSIDE" mark
Servicing Your Honda
(1)
139