How To Remove And Install The Pullout Drawer - Amana ARB2257CSR Owner's Manual

5. While holding refrigerator
door upright, tighten
down top hinge with "
5 Ú
16
hex head driver and
replace hinge cover.
How to remove and
install the pullout
drawer
WARNING
To avoid electrical shock which can
cause severe personal injury or death,
disconnect power to refrigerator
before removing doors. After replacing
doors, connect power.
CAUTION
To avoid possible injury, product, or
property damage, you will need two
people to perform the following
instructions.
REMOVING PULLOUT
DRAWER
1. Pull drawer open to full extension.
Remove Phillips screw from each side
of rail system.
2. Remove lower basket by lifting basket
from rail system.
3. Pull upper basket out to full extension,
and lift out to remove.
4. Lift top of door to unhook door
supports from rail system. Lift door out
to remove.
INSTALLING PULLOUT
DRAWER
1. Pull both rails out to full extension.
2. Hook door supports into rail tabs, as
illustrated, and lower door into final
position.
3. With drawer pulled out to full exten-
sion, insert lower basket by aligning
tabs on both side of lower basket with
notches in rail assembly.
4. Slide upper basket into unit. Make
sure that rear of basket hooks behind
rail catch.
7