Freezer Features; Automatic Ice Maker; Ice Service Rack; Wire Basket - Amana ARB2257CSR Owner's Manual

Freezer features

Primary features

AUTOMATIC ICE MAKER

(SOME MODELS)
CAUTION
To avoid property damage, observe
the following:
Do not force ice maker arm down
or up.
Do not place or store anything in
ice storage bin.
Using Ice Maker for the First Time
1. Confirm ice bin is in
place and ice maker
arm is down.
2. After freezer section reaches between
0° to 2° F (-18° to -17° C), ice maker
fills with water and begins operating.
3. Allow approximately 24 hours after
installation to receive first harvest of
ice.
4. Discard ice created within first 12
hours of operation to verify system is
flushed of impurities.
Operating Instructions
1. Confirm ice bin is in place and ice
maker arm is down.
2. After freezer section reaches 0° to 2° F
(-18° to -17° C), ice maker fills with
water and begins operating. You will
have a complete harvest of ice
approximately every 3 hours.
3. Stop ice production
by raising ice maker
arm until click is
heard.
4. Ice maker will remain in the off posi-
tion until arm is pushed down.
Shelves

ICE SERVICE RACK

To install and
remove rack:
To install, slide
L - s h a p e d
1
groove of shelf
2
down over back
wall screw. Push rack back until screw
is stopped in L-shaped groove (1) .
Slide front portion of shelf over front
wall screw (2).
To remove, perform above steps in
reverse order.
FIXED FREEZER SHELF
To remove and install shelves:
Remove shelf
by pulling out
to full exten-
sion. Tilt up
front of shelf
and pull straight out.
To install, insert shelf into refrigerator
liner rails and push to back of com-
partment.
SLIDE-OUT FREEZER
SHELF
To remove and
install shelves:
Remove shelf by
pulling out to full
extension. Tilt up front of shelf and pull
straight out.
To install, insert shelf into refrigerator
liner rails and push to back of com-
partment.
Drawers

WIRE BASKET

To remove and install basket:
To remove
basket, pull
basket out to
full exten-
sion. Tilt up
front of basket and pull straight out.
To install, insert basket into refrigera-
tor liner rails and push back into place.

PULLOUT DRAWER

BASKETS
(SOME MODELS)
(Door assembly of drawer removed from
illustration for visual clarity.)
To remove and replace top basket:
Remove basket by pulling basket out
to its full extension and lift out.
Replace basket by sliding into upper
molded railing.
To remove and replace bottom basket:
Remove basket by lifting basket from
rail guides.
Replace basket by placing into rail
guides.
DANGER
To prevent accidental child entrap-
ment or suffocation risk, DO NOT
remove the divider in the top freezer
basket.
13