How To Replace The Doors And Hinges - Amana ARB2257CSR Owner's Manual

Installing your refrigerator,
3. Remove two remaining
handle screws
remove handle.
• Retain screws for later
replacement.
INSTALLING FREEZER
HANDLES
If installing handles for the first time, the
freezer handles can be located in the
literature pack.
Install handle by
fastening with screws
removed from edge
of door.
• If reversing freezer door, remove
door plugs from top edge of door and
insert into screw holes.
REMOVING FREEZER
HANDLES
Removing handles may be necessary
when transporting unit through tight
spaces, or when reversing the door.
Remove handle
screws with Phillips
screwdriver.
• Retain screws for
later replacement.
INSTALLING FRESH FOOD
SIDE-MOUNTED HANDLES
Install handle by
fastening with T-15
Torx * screws re-
®
moved from edge of
door.
NOTE: If reversing door, remove door
plugs from opposite side of door and
insert in screw holes.
REMOVING FRESH FOOD
SIDE-MOUNTED HANDLES
Removing handles may be necessary
when transporting unit through tight
spaces, or when reversing the door.
* Torx is a registered trademark of Textron Inc.
6 ®
Remove handle by
and removing
T-15 Torx
from side of door.
• Retain screws for
later replacement.
INSTALLING FREEZER
HANDLES
Install handle by fasten-
ing with T-15 Torx
screws removed from
edge of door.
REMOVING FREEZER
HANDLES
Removing handles may be necessary
when transporting unit through tight
spaces.
Remove
removing three T-15
Torx
handle.
• Retain screws for later replacement.
INSTALLING STAINLESS
STEEL FRONT-MOUNTED
HANDLES
1. Loosen door clip on door
with
2. Locate predrilled hole
at base of handle, and
fit hollow end of handle
over door clip.
3. Fit other end of handle over other door
clip and slide up as far as possible.
NOTE: If top of handle does not fit
over top clip, loosen lower clip further
until fit can be accomplished.
4. Insert
er into predrilled hole at
base of handle to tight-
en screw. Insert screw
plug(s) into hole(s), as
illustrated.
cont.
three
* screws
®
*
®
handle by
® * screws from
1 " hex head driver.
Ú
4
1 " hex head driv-
Ú
4
REMOVING STAINLESS
STEEL FRONT-MOUNTED
HANDLES
Removing handles may be necessary
when transporting unit through tight
spaces.
1. Remove screw plug at base of handle
with a very small flat-blade screw-
driver.
• Insert " hex head
1 Ú
4
driver into predrilled
hole to remove screw.
2. Slide handle to remove
from door clip.
How to Replace the
Doors and Hinges
1. Install hinge assemblies.
• Install top hinge loosely with
head screws.
• Install center hinge with Phillips
screws.
• Install bottom hinge with
screws.
2. Insert bottom
hinge pin (some
models).
• Locate bottom
hinge hole
closest to out-
side edge of
cabinet, and
insert bottom hinge pin. Replace any
door shims, if present.
3. Place hinge side of freez-
er door on bottom hinge
pin and hold freezer door
upright while installing
center hinge pin with
5
driver.
• Replace any applicable door shims.
• Make sure the hinge pin is installed
tight.
4. Place hinge side of refrigerator door
on center hinge pin.
" hex
5
Ú
16
3 " hex head
Ú
8
" hex head
Ú
16