Electrical Connection Clearance; Gas Connection Requirements; Gas Supply Location - Amana ARG3600 Series Owner's Manual

Use a dedicated 120 volt, 60 hertz, 3-prong receptacle
protected by a 15 amp circuit breaker or time delay fuse.
A qualified electrician should confirm the outlet is properly
grounded.
If a 2-prong outlet is encountered, range owner must
replace outlet before using range. Do not cut off cord,
use plug adapter or extension cord, or remove
grounding plug.
Grounded Plug and Receptacle

Electrical Connection Clearance

Electrical connection must be located in the shaded area
shown. Electrical connection must not interfere with gas
connection.
A
B
1
A—2 / inches (Both sides)
8
B—19½ inches
C—12 inches
D—20 inches
E—30 1 /
4
Electrical Connection Location
D
C
E

Gas Connection Requirements

Before connecting this appliance to the gas supply piping
system, confirm installation meets the requirements of local
codes, or in the absence of local codes, with the National
Fuel Gas Code, ANSI Z223.1-Latest Edition.
When installed in mobile housing, installation is to be in
accordance with CSA standard Z241.1 gas equipped
mobile housing.
The installation of appliances designed for manufactured
(mobile) home installation must conform with
Manufactured Home Construction and Safety Standard,
Title 24 CFR, Part 3280, or when such standard is not
applicable, the Standard for Manufactured Home
Installation, ANSI225.1/NFPA 501A-Latest Edition, or with
local codes or the standard CAN/CSA-z240MH, "Mobile
Homes", and with local codes where applicable.
The installation of appliances is to be in accordance with
CAN1-B149.1 or B149.2 installation code for gas burning
appliances and equipment and/or local codes. Part 1 and/
or local codes.

Gas Supply Location

Gas supply must be located in the shaded area shown.
Gas connection must not interfere with the electrical
connection.
A
B
A—26 inches
B—20 inches
C—2¼ inches
D—4 inches
E—6 inches
Gas Supply Location
7
C
D
E