Table of Contents
Advertisement
AUTOMATIC TRANSMISSION - COMPONENT PARTS REMOVAL
(b)
Push the center support toward the rear of the tra-
nsmission by applying a force of 49 — 98 N (5 — 10 kgf,
11.0 — 22.0 Ibf), then pull with the same amount of
force.
(c)
Place SST on the center support.
SST 09350-36010(09350-06090)
(d)
Using calipers, measure distance (A) between the tops
of SST and the thrust washer on the front planetary
gear.
(e)
Using calipers, measure the thickness (B) of SST.
(f)
Remove the three center support set bolts.
(g)
Using SST, remove the center support assembly.
SST 09350-36010(09350-06140)
(h)
Turn the center support together with the thrust
washer, and place it on that surface,
(i)
Inserting the calipers into the thrust washer hole,
measure the distance (C) between it and the flat sur-
face.
Center support thrust clearance:
A - ( B + C)
Standard thrust clearance:
0.30-0.70 mm (0.0118-0.0276 in.)
AT-25
Advertisement
Table of Contents
