Table of Contents
Advertisement
AUTOMATIC TRANSMISSION - COMPONENT PARTS INSTALLATION
COMPONENT PARTS INSTALLATION
Disassembly, inspection and assembly of each component group have been indicated in the preceding
chapter. Before assembly, make sure again that all component groups are assembled correctly.
If something wrong is found in a certain component group during assembly, inspect and repair this
group immediately.
Recommended ATF: DEXRON
GENERAL INSTALLATION NOTES
1.
The automatic transmission is composed of highly precision—finished parts, necessitating
careful inspection before assembly because even a small nick could cause fluid leakage of affect
performance.
2.
Before assembling new clutch discs, soak them in automatic transmission fluid for at least fifteen
minutes.
3.
Apply automatic transmission fluid on sliding or rotating surfaces of parts before assembly.
4.
Use petroleum jelly to keep small parts in their places.
5.
Do not use adhesive cements on gaskets and similar parts.
6.
When assembling the transmission, be sure to use new gaskets and O —rings.
7.
Dry all parts with compressed air, never use shop rags.
AT-101
Advertisement
Table of Contents
