Wired remote control
If an error occurs,
If you would like to see an error code, press the Test button.
Display
Indoor unit Communication Error
Indoor/Outdoor unit Communication Time Out Error
60 Packet Over data
Indoor unit is not connected
Communication Error between Outdoor Main and Inverter Micom
(Occurred after 1 minute detection in Main and Inverter)
Indoor Temp. Sensor (Open/Short Error)
Indoor Unit Eva in Sensor (Open/Short Error)
Indoor Unit Eva in Sensor Separation
Outdoor Temp. Sensor Error (Open/Short Error)
COND Temp. Sensor Error (Open/Short Error)
Inverter Compressor Discharge Temp. sensor Error
(Open/Short Error)
Power cable miss connection error
Indoor Float S/W 2 nd Detection
Outdoor unit - indoor unit communication wire miss connection
(Connected to Power terminal)
Outdoor unit refrigerant Full leakage (Gas leak)
Outdoor Fan 1 Error
Outdoor Fan 2 Error
Discharge over temperature
[Inverter] Compressor starting error
Primary Current Over Trip error
[Inverter] DC PEAK error(O.C)
[Inverter] Compressor Rotation error
[Inverter] Current Sensor error
[Inverter] DC LINK Sensor error
[Inverter] EEPROM Read/Write Error
[Inverter] Heatsink temperature over Error
Outdoor unit Capacity Setup option error
Communication error between Indoor unit and wired remote control
Communication error between Master and Slave wired remote control
COM1/COM2 Cross-installed error
Error of setting option for wired remote control COM2
4-6
is displayed on the wired remote control.
Explanation
Remark
Communication Error
Indoor Sensor Error
Outdoor Sensor Error
Self Diagnosys Error
Outdoor Unit Protection
Control Error
Wired Remote Control Error
Samsung Electronics