Mazda 5 2007 Manual page 290

Maintenance and Care
Owner Maintenance
Front turn signal lights/Side-marker
lights
1. Turn the center section of the plastic
retainers counterclockwise and remove
them, then partially peel back the
mudguard.
2. Turn the socket and bulb assembly
counterclockwise and remove it.
3. Remove the bulb by pushing it in
slightly and turning it
counterclockwise.
4. Install the new bulb in the reverse order
of removal.
Side turn signal lights
1. Slide the unit as shown in the figure to
remove it.
8-42
Removal
Installation
2. Disconnect the electrical connector
from the unit.
3. Install the new side turn signal unit in
the reverse order of removal.
NOTE
Bulb replacement is not possible
because it is built into the unit. Replace
the unit.
Brake lights/Taillights, Rear turn signal
lights, Reverse lights
1. Wrap a flathead screwdriver with a soft
cloth to prevent damage to the rear
combination component and gently
insert it in the cover as shown in the
figure, and then remove the cover.