HP EliteDesk 705 G2 Small Form Factor Maintenance And Service Manual page 76

Table 5-1 Computer Setup—Main (continued)
System IDs
Replicated Setup
Save Custom Defaults
Apply Custom Defaults
and Exit
Apply Factory Defaults
and Exit
Ignore Changes and Exit
Save Changes and Exit
Suppress POST Errors
66 Chapter 5 Computer Setup (F10) Utility
● Serial Number
● SKU Number
Product Family
●
● System Board CT
● Product Name
Lets you clear the following values:
● Asset Tracking Number
● Ownership Tag
Backup current settings to USB device
Saves system configuration to a formatted USB flash media device.
Restore current settings from USB device
Restores system configuration from a USB flash media device.
Saves the current system configuration settings as the default.
Applies the currently selected default settings and clears any established passwords.
Restores the factory system configuration settings as the default.
Exits Computer Setup without applying or saving any changes.
Saves changes to system configuration or default settings and exits Computer Setup.
Suppresses most system messages during POST (Power On Self Test).
POST error messages are displayed on the display during the Power On Self Test if the BIOS encounters a
problem while starting the computer. A POST error message will only display on screen if the computer is
capable of booting this far. If the POST detects an error before this point, a beep code is generated
instead.