Bionaire BOF3001-CN Instruction Leaflet page 8

Table of Contents

Advertisement

Problem
The heater will
Heater is not plugged into a 120V
polarized outlet/receptacle.
not power on.
Breaker/Fuse has been tripped.
Power light is
Room temperature has warmed up to
on, but no heat
thermostat setting.
is emitting from
The heating elements inside the unit
the unit.
have not warmed up yet.
The heater is
Check & ensure there are no
creating a
combustible materials 3' (0.9 m)
burning smell.
surrounding the heater.
The heater feet have not been
properly installed on the unit.
The heater is
It is normal for the heater to emit
making small
small crackling sounds as it heats the
crackling sounds.
oil inside the fins.
© 2014 Sunbeam Products, Inc. doing business as Jarden Consumer Solutions. All rights reserved. Imported and
distributed by Sunbeam Corporation (Canada) Limited doing business as Jarden Consumer Solutions, 20B Hereford
Street, Brampton, Ontario L6Y 0M1.
If you have any questions regarding your product or would like to learn more about other Bionaire
contact our Consumer Service Department at 1-800-253-2764 or visit our website at www.bionairecanada.com.
For inquiries regarding recycling and proper disposal of this product, please contact your local waste management facility.
T R O U B L E S H O O T I N G
Probable Cause
Ensure unit is in OFF position. Plug in unit and attempt to turn
on again.
Check your electrical box to confirm the breaker has not been
blown. This may occur if the receptacle is shared between
other high consumption appliances. Ensure unit is in the OFF
position. Plug in unit and attempt to turn on again. Attempt to
plug unit into another receptacle in the house.
To increase the room temperature, adjust thermostat control
knob to a higher setting by turning clockwise.
Allow 15 minutes after the unit has been turned on for the oil
fins to heat.
Remove the combustible units adjacent to the heater.
Follow assembly instructions on how to attach front and hind
legs to the unit.
Allow heater to operate for a period of time. After the heater
has warmed up, the crackling sounds should stop. Do not be
alarmed. It will go away after approximately 15 minutes.
Solution
products, please
®
Printed In China

Advertisement

Table of Contents
loading

Table of Contents