Honda TRX420FA1 Owner's Manual page 152

14 TRX420FA1 FA2-32HR3B000.book 144 ページ ２０１３年９月６日 金曜日 午後１時５７分
Front Final Gear Oil
1. Park your ATV on a firm, level surface.
2. Place an oil drain pan under the oil drain bolt (1).
3. Remove the oil fill cap (2), O-ring, drain bolt and sealing washer.
4. After the oil has completely drained, reinstall the drain bolt with
a new sealing washer and tighten it to the specified torque:
12 N·m (1.2 kgf·m , 9 lbf·ft)
5. Pour the drained oil into a suitable container and dispose of it in
an approved manner (page 210).
NOTICE
Improper disposal of drained fluids is harmful to the environment.
6. Fill the front final gear with the recommended oil.
210 cm 3 (7.1 US oz , 7.4 lmp oz)
Make sure the oil level is at the lower edge of the oil fill inspection
hole (3).
7. Coat a new O-ring with grease and install it into the fill cap
groove and tighten it to the specified torque:
12 N·m (1.2 kgf·m , 9 lbf·ft)
FRONT
(3)
(1)
(1) oil drain bolt
(2) oil fill cap
144
Servicing Your Honda
(2)
(3) oil fill inspection hole