Honda TRX420FA1 Owner's Manual page 146

14 TRX420FA1 FA2-32HR3B000.book 138 ページ ２０１３年９月６日 金曜日 午後１時５７分
Engine Oil & Filter
Install a New Engine Oil Filter:
Place shop towels under the oil filter cover because oil will flow out.
1. Remove the oil filter cover (1) and O-rings (2) by removing the
bolts (3). Let the remaining oil drain out. Discard the oil filter (4)
in an approved manner (page 204).
2. Apply engine oil to a new O-ring and install it to the oil filter
cover. Then install a new oil filter. Use only the Honda Genuine
oil filter or a filter of equivalent quality specified for your model.
Using the wrong Honda filter or a non-Honda filter which is not
of equivalent quality may cause engine damage.
3. Install a new filter with the rubber seal (5) facing inward, toward
the engine. Make sure the spring (6) and the OUT SIDE mark (7)
faces away from the engine, toward the oil filter cover.
NOTICE
Improper installation of the oil filter can cause serious engine
damage.
RIGHT SIDE
(5)
(1) oil filter cover
(2) O-ring
(3) bolts
(4) oil filter
138
Servicing Your Honda
(4) (6)
(7) (2)
(5) rubber seal
(6) spring
(7) OUTSIDE mark
(1)
(3)