Table of Contents
Advertisement
OPERATION
1
2
1. Intermittent nailing
2. Continuous nailing
3. Change lever
4. Trigger lock
8
CAUTION:
•
Make sure all safety systems are in working order before operation.
1.
To drive a nail, you may place the contact element against the workpiece
and pull the trigger, or
2.
Pull the trigger first and then place the contact element against the work-
piece.
•
No. 1 method is for intermittent nailing, when you wish to drive a nail
005245
carefully and very accurately.
No. 2 method is for continuous nailing.
CAUTION:
•
However when the tool is set to the "Intermittent Nailing" mode, WITH
THE TRIGGER HELD IN A HALF-PULLED POSITION, an unexpected
nailing could occur, if contact element is allowed to re-contact against the
workpiece or the other surface under the influence of recoil.
In order to avoid this unexpected nailing, perform as follows;
A.
Do not place the contact element against the workpiece with excessive
005246
force.
B.
Pull the trigger fully and hold it on for 1-2 seconds after nailing.
•
For No. 1 method, set the change lever to the "Intermittent Nailing"
005247
position. For No. 2 method, set the change lever to the "Continuous
Nailing" position. After using the change lever to change the nailing
method, always make sure that the change lever is properly set to the
position for the desired nailing method.
3
CAUTION:
•
Operating the tool without nails shortens the life of the tool and should be
avoided.
4
Anti exhaust
•
Air exhaust direction can be changed easily by rotaiting the exhaust
cover. Change it when necessary.
Advertisement
Table of Contents
