System Configuration - Furuno FAR-2827W Installation Manual

SYSTEM CONFIGURATION

FAR-2827W
Antenna Unit
XN20AF-RSB-103
XN24AF-RSB-103
(For de-icer)
RU-3305
Waveguide
WRJ-9 or FR-9
1)
IEC-61162-1 Serial Data*
Navigator
(Input/Output)
2)
IEC-61162-1 Serial Data
Speed Log
Step or synchro signal
3)
Gyro Compass
AD-100
IEC-61162-2
AIS
Switching HUB HUB-100
Track Control Unit
Memory Card
Interface Unit
CU-200-FAR
: Standard
: Option
: Dockyard supply
1
* When length of antenna cable is more than 100 m.
2
* For IMO spec, IEC-61162-1 Edition 2 is required.
3
* Russian flag vessels only.
4
* Contact output for Alarm
(Load current) 120 mA, (Polarity) No.1/2: Normally Close, No.3/4: Normally Open
Serial I/O for alarm is also possible, which complies with IEC 61162-1.
5
* This monitor has been approved by the IMO (CAT1). If a different monitor is to
be used, its effective diameter must meet the applicable Category requirements
(effective diameter 320 mm or higher). Refer to its operator's manual for details.
1) Connect the EPFS which is approved in accordance with the requirements of the IMO in
resolution MSC.112(73) is used.
2) Connect the SDME which is approved in accordance with the requirements of the IMO
in resolution MSC.96(72) is used.
3) Use the gyrocompass having an update rate that is adequate for the ship's rate of turn.
Transceiver unit
RTR-081A
RJB-001*
RJB-001*
2 Processor Unit
RPU-013
(Input)
Gyro Converter
GC-10
Power Supply Unit*
PSU-011
Performance Monitor
Monitor Unit
MU-231CR
or
MU-231
Control Unit
RCU-014
1
(Standard)
or
RCU-015
(Trackball)
1
Control Unit
RCU-016
(Remote)
Sub Display
4
*
Alarm
VDR
External Monitor
3
Transformer Unit
RU-1803
vi
5
*
100-230 VAC
Category of Units
Antenna unit: Exposed to weather
All other units: Protected from weather