Sanyo VPC-S60 Service Manual page 20

3-8. Factory Code Setting
1. Check the "Factory Code" display within the Setting group.
2. For U.S.A., Canada and NTSC general area
If "FC_SANYO_U" does not appear, click on the "
located on the right of the "Factory Code" display BOX and
select "FC_SANYO_U".
3. For Europe and PAL general area
If "FC_SANYO_EX" does not appear, click on the "
located on the right of the "Factory Code" display BOX and
select "FC_SANYO_EX".
3-9. Language Setting
1. Click on the " " mark located on the right of the
"Language" display BOX.
2. Select language. (Default is English.)
3. End "DscCal" and remove the camera before turning the
camera power OFF.
Calibration Upload LCD
R Bright
AWB
Firmware
Focus
RGB Offset
Data
UV Matrix
Tint
Cal Mode
PAF Cal.
OK
EVF VCO
H AFC
Cal Data
LCD Type
OK
USB storage
VID
Get Set Serial
Set PID
Backrush pulse :
Get
" mark
" mark
B Bright VCOMDC
Gain VCOMPP
Phase
Hall Cal.
Test
Setting
Language
Set
Video Mode
Set Rev. Set
Factory Code
Set
3-10. Program data writing to NAND-Memory
Carry out program data writing to NAND-memory
after replacing CP1 board.
Preparation:
SD card: SD card with data written into the root directory
Data: S81RNxxx.bin (xxx: version)
Overwriting method:
1. Insert the above SD card.
2. Turn on the camera.
3. Press the PLAYBACK button.
4. Press the MENU button. The playback menu appears.
5. Press the down arrow button. The option menu appears.
6. Press the left arrow button for 2 seconds.
FIRMWARE UPDATE will display.
7. Choose YES.
8. Press the SET button. Update is starting.
Note:
Do not turn off the camera's power or remove the SD card
while the firmware is being updated.
3-11. Reset Setting
Carry out reset settings after replacing CP1 board.
1. Turn on the camera.
2. Press the MENU button.
3. Choose the OPTION.
4. Choose the RESET SETTINGS, and press the SET
button.
5. Select Yes, and press the SET button.
– 20 –