Renault 2016 TALISMAN Handbook page 50

CHILD SAFETY: fitting a child seat, general information
In the rear seat
A carrycot can be installed across the
vehicle and will take up at least two
seats. Position the child with his or her
feet nearest the door.
Move the front seat as far forward as
possible to install a rear-facing child
seat, then move back the seat in front
as far as it will go, although without al-
lowing it to come into contact with the
child seat.
For the safety of a child in the facing
forwards, move the seat as far back as
possible and move the seat in front of
the child forward, remembering to move
the seatback forwards to avoid contact
between the seat and the child's legs.
Always remove the headrest from the
rear seat used for the child seat (see
"Rear headrests" in Section 3). If nec-
essary, position the vehicle seat as far
back as possible. This must be done
before fitting the child seat.
Check that the child seat is resting
against the back of the vehicle seat.
1.44
A child seat with support
struts must never be in-
stalled on the rear centre
seat. RISK OF DEATH OR
SERIOUS INJURY.
When fitting a child seat
(Group 2 or 3 booster seat),
check that the seat belts op-
erate (wind) correctly: refer
to Section 1 "Rear seat belts". If
necessary, adjust the position of the
vehicle seat.
Ensure that the child seat or
the child's feet do not pre-
vent the front seat from loc-
king correctly. Refer to the
information on the "Front seat" in
Section 1 or "Rear seat operation"
in Section 3.
(2/2)