Dolmar PS-35 C Repair Manual page 19

08 CARBURETOR
4
10
9
8
ON
Make sure that the intermediate fl ange goes
into its space on the cylinder side.
When lowering the cylinder make sure that the
pulse line 11 and the red fuel line 7 enter the
carburetor area.
Before completely lowering the cylinder make
sure that the short-circuit cable is led into the
openings 10.
Make sure that the return line (right primer
connection) is behind the guide 12.
Install the combination switch 1 with the short-
circuit cable on top and then press the short-
circuit cable 9 under the holder 8.
Install the contact spring with short-circuit
cable.
Repair Manual PS-35
Tighten the cylinder head bolts by hand
evenly alternating crosswise and then tighten
11
to the right torque (10 +/- 0.5 Nm), likewise
alternating crosswise.
7
Screw in screws 4.
12
Check the cylinder side annular spring on the
fl ange for correct seating.
Note: Before inserting the carburetor, make
sure that the carburetor mounting fl ange is
positioned horizontally.
Insert the carburetor and pulse line, and
connect the fuel lines.
Install the intake manifold 3 (3 +/-0.5 Nm).
Schematic diagram of the fuel lines
Red fuel line
Note: When installing the tank suction line,
make sure that the nose on the connection
nipple 13 is pushed into the position on the
connection as shown.
13
19